1995 DODGE DAKOTA 2DR EXT CAB PICKUP
Security
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AllDoorTrigger YEL (-) DRIVER'S PIN SWITCH
TrunkTrigger N/A
HoodTrigger N/A
ParkingLights BLK/YEL(+) (+) AT LIGHT SWITCH
Remote Start
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Ignition DK.BLU (+) IGNITION SWITCH HARNESS
Ignition02 BLK + (+) IGNITION SWITCH HARNESS
Ignition03 +
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS
Accessory02 +
Starter01 YEL(+) + (+) IGNITION SWITCH HARNESS
AntiTheftSystem NONE
KeySense LT.BLU (-) (-) STEERING COLUMN HARNESS
NeutralSafety BRN/YEL (-) DRIV SIDE OF TRANS.
Tach GRY (-) (-) AT COIL
SpeedSense WHT/ORG (AC) LEFT REAR OF TRANS,3 PIN PLUG
ParkingLights BLK/YEL(+) (+) AT LIGHT SWITCH
BrakeLights WHT (+) OR WHT/TAN AT BRAKE SWITCH
ReverseLights VIO/BLK (+) (+) DRIV SIDE OF TRANS
Horn DK.GRN/RED(-) AT FUSEBOX
Doorlocks / Window
PowerUnLock PNK/PPL (REV) REVERSE POLARITY
PowerLock ORG/PPL (REV) DRIVER'S KICK PANEL
LeftFrontWindow01 LF:LT.BLU
RightFrontWindow01 RF:BRN/WHT
LeftRearWindow01 LF:WHT
RightRearWindow01 RF:VIO/WHT
Convenience
HeadLights LT.GRN (+) AT LIGHT SWITCH
TrunkRelease N/A
CAB PICKUP
Mobile Audio / Video
Battery PNK/BLK + (+) IGNITION SWITCH HARNESS
Accessory01 BLK/ORG + (+) IGNITION SWITCH HARNESS
Ground N/A -
Illumination BLK/YEL (+) RADIO HARNESS
Dimmer ORG (+) RADIO HARNESS
FrontLeftSpeakerPos DK.GRN
FrontLeftSpeakerNeg BLU/ORG
FrontRightSpeakerPos VIO/WHT
FrontRightSpeakerNeg BROWN/BLUE
RearLeftSpeakerPos BRN/YEL
RearLeftSpeakerNeg BRN/RED
RearRightSpeakerPos BLU/WHT
RearRightSpeakerNeg BLU/RED
Amp NOT LIKELY
Control Modules
Note:
Wirediagram.com makes no representation or warranty with respect to the above information including its accuracy, completeness, or its freedom from third parties' proprietary rights. Wirediagram.com disclaims all liability or responsibility for errors or omissions therein or any decision made by the recipient in reliance thereon. The installer must verify any circuitry with the proper test equipment prior to installation.
